CareerExamPro

Hyperscale hardware fiber ops practice questions

24 questions from the CDCP, CDCS, DCCA & Cisco CCT Data Center practice test.

Start practicing

Hyperscale hardware fiber ops practice drill

10 realistic exam questions, graded as you go, with the exact rule or statute citation for every answer. Start free, no sign-up.

Sample questions

Under EIA-310-D / IEC 60297 rack standards, what is the vertical height of one rack unit (1U), and where should the heaviest storage JBODs or rack-mount UPS units be installed inside a 42U cabinet?

  1. 1.75 in (44.45 mm); mount heaviest chassis at the bottom for stability.
  2. 2.00 inches (50.80 mm); mount the heaviest chassis at the top to aid natural convection cooling.
  3. 1.50 inches (38.10 mm); mount the heaviest chassis in the middle at 20U–24U for ergonomic access.
  4. 1.75 inches (44.45 mm); mount the heaviest chassis at the top so overhead cable trays support them.
Show the answer

A. 1.75 in (44.45 mm); mount heaviest chassis at the bottom for stability.

One standard rack unit (1U) equals 1.75 inches (44.45 mm), containing three mounting holes spaced across the rail. Heavy equipment (UPS modules, battery packs, dense storage enclosures) must always be mounted at the bottom of the rack to lower the center of gravity and prevent tip-over hazards when sliding rails out.

Reference: ANSI/EIA-310-D & IEC 60297-3-100 — 19-Inch Rack Standards

A technician decommissions four 2U compute nodes from the middle of a 42U cabinet in a cold-aisle-contained row, leaving an 8U open gap. Why must snap-in blanking panels be installed immediately?

  1. To provide structural shear bracing required to hold the remaining servers on their slide rails.
  2. To block hot rear exhaust from recirculating into cold server intakes.
  3. To increase static air pressure inside the hot aisle so CRAC return fans draw less electrical current.
  4. To satisfy NFPA 70E arc-flash containment rules for low-voltage Ethernet patch cables.
Show the answer

B. To block hot rear exhaust from recirculating into cold server intakes.

Open U-spaces create a low-resistance short circuit allowing hot exhaust air from the rear of the rack to pull straight back into the cold aisle and enter adjacent server intakes, causing localized thermal hotspots and higher server fan power draw. Installing blanking panels seals the front plane.

Reference: ASHRAE TC 9.9 & ANSI/TIA-942-C Section 5 — Rack Blanking Panels

A database server runs a 6-drive RAID 6 array using 4 TB enterprise NVMe drives. Two drives fail over a holiday weekend before a technician arrives. What is the status of the array and its usable capacity?

  1. The array has lost all data because parity arrays can only survive a single drive failure.
  2. The array remains online in degraded mode with 20 TB usable capacity (one parity drive).
  3. Online in degraded mode with 16 TB usable capacity (dual parity).
  4. The array remains online in degraded mode with 12 TB usable capacity (mirrored pairs).
Show the answer

C. Online in degraded mode with 16 TB usable capacity (dual parity).

RAID 6 uses block-level striping with dual independent distributed parity (N - 2 usable capacity). With six 4 TB drives, usable capacity is (6 - 2) × 4 TB = 16 TB, and the array can tolerate up to two simultaneous drive failures while staying online in degraded mode.

Reference: SNIA Common RAID Disk Data Format (DDF) Specification — RAID 6

Other topics